Hanging Planter1. Start with a pallet
2. Remove every other board on one side.
3. Cut pallet just to the left of the middle board so the left piece has two boards closing the sides.
4. Remove four boards from the right piece you cut. Trim the boards so they fit what will be the bottom of your planters.
5. Screw the pieces you trimmed into the gaps creating the bottom of your planter shelves.
6. Place the planter upright. Attach two chain to the top left and right sides of the planter.
7. Hang planter.
|
Little Library1. Start with a pallet.
2. Disassemble the pallet.
3. Cut:
11 pieces 21" long (red) 8 pieces 20" long (orange) 6 pieces 17" long (yellow) 2 pieces 16" long (green) 1 piece 21" long and half the width (light blue) 2 pieces 18" long and half the width (blue) 1 piece 17" long and half the width (purple) 2 pieces 16" long and half the width (pink) Lay 6 21" pieces next to each other. Nail 2 20" pieces on each side of the 21" pieces. 4. Nail one of the 18" pieces that are half the length to 3 20" pieces. Repeat.
5. Attach the two pieces you just made to the 20" pieces on the base. Then nail the 2 16" half width pieces to 4 17" pieces.
6. Attach the piece you just made to the 20" pieces creating the back of the library. Then nail 2 17" pieces and 16" pieces to form a square (as shown above) and then nail the 17" half width piece to the top of the square you created. Creating the door.
7. Place door on the front and add hinges to one side.
8. Nail the 21" half width piece to the top of the library. Then repeat with 5 21" pieces.
9. Attach plexiglass to the interior of the door.
|
Chair1. Start with a pallet.
2. Cut the pallet just to the left of the middle board creating one piece that has a board on each side keeping it together. Place other piece to the side for now.
3. Cut just after the fourth board from one side of the remaining pallet piece. Creating piece 2 and 3.
4. Remove two boards from the piece 1 (the one you set aside earlier) and screw them into the last board of piece 2.
5. Place piece 3 on the boards you just attached. Secure piece 3 by screwing it to the boards.
6. You can add legs by taking extra boards from piece 1 and screwing them to the bottom of the chair.
|